CURRENTLY SOLD OUT
 | Shop by category |
{"delay":300}
|
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Doorbells
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Doorbells
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
It works very well - good sound & loud enough. Should mention that it does not actually say 'Friedland' on it & is in a package labelled 'Newlec'. Presumably manufactured to Friedland design. Should also mention that due to its design, functions on AC only - ie bell transformer required, Also important to mount it the right way up!
Verified purchase: Yes | Condition: New
A basic wired low voltage bell. Simple and easy to install. Note -requires suitable transformer and bell push for operation (not included). Good sound level.
Verified purchase: Yes | Condition: New
Bought this a few years ago. The original of same design lasted 18+ years and stopped working as the contacts had tarnished. I have bought another to replace a box shaped bell which only lasted a few years and basically had fell apart internally. This bell is loud and robust. The screws to attach the bell have small heads allowing them to fit inside the holes in the housing. Unfortunately the screws were to narrow for the existing brown 7mm plugs in the ceiling. So I just used some longer and slightly thicker screws. Make sure your wiring does not touch the bell housing as this will affect the sound. I used an existing 8volt 1amp power supply to power the bell. Make sure you screw the dome in straight and not to tight, there should be a nice ting sound when you flick it Wiring: From the transformer, one wire goes the door bell, the return wire from the door bell goes to one contact on the bell. The other wire from the transformer goes directly to the other contact on the bell. If you are replacing a bell box, it might have had separate contacts for each wire (4 wires all together) so in this case one wire from the transformer needs to be connected directly to one wire from the bell. As only 2 contacts are provided. I twisted the 2 together. Its preferable to connect 8v neutral to the door bell and the 8v live directly to the bell. This might be different if you have a lit door bell.Read full review
Verified purchase: Yes | Condition: New
I had wanted a bell to waken the dead but I now realise that they can only be 90db tops, the best thing I can do is make my own pull bell.
Verified purchase: Yes | Condition: New
We moved house recently and the two old versions of this bell gave a pathetic buzz that we were unable to hear in the next room. Since these were so well reviewed, not expensive and would just fit over the existing wiring, I thought I'd give them a go. Works like a dream - very loud. Can hear at least two floors away in our town house. Recommend.
Verified purchase: Yes | Condition: New
