CURRENTLY SOLD OUT
 | Shop by category |
{"delay":300}
|
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Boards & Cases
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Boards & Cases
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
Very good value, managed to fit 12 Boss pedals on the board. Have to use right angled plugs for power and jack leads though. Keeps all my pedals in one place, only used at home.
Verified purchase: Yes | Condition: New
Arrived very quick and is the cheapest hard case i could find that was a decent size. Seems to be of good build quality but unusually has not got the velcro (loop) lining that my Stagg hard case has. With my other case i just affix the velcro (hook) tape to the bottom of a pedal and stick it anywhere in the case. On this however there is one strip along the centre which is actually the hook part of velcro! weird. Anyway make sure you buy both the hook and loop velcro tape if you want to use this, also the feet on mine are on the top part of the case and riveted on which is also quite irritating, if you can put up with this and wanna save £20 id recommend though.
Verified purchase: Yes | Condition: New
The construction is plastic not aluminium. The only aluminium parts on this case is the corners. The velcro is useless, I couldn't see a use for it and it is on the deeper side so your foot has to go lower inside. So forget trying to put a wah or volume pedal on it. The sponge is useless also, once you layout your board and try to close it, you can't. Simple as that. You'd end up breaking all the knobs on your pedals. I will use it but will have to glue some proper carpet down on the SHALLOW SIDE and then put some velcro on my pedals AND REMOVE the sponge. Then screw some rubber feet on the bottom in order for this case to stop moving once you go to press a pedal. I should think for the price you pay for what you get but I found it overall a bit misleading.
Verified purchase: Yes | Condition: New
For the money it does a good job, the Velcro strip for applying the pedals to is on the thinner side of the case, which makes sense as you can rest your foot on side of case and still use pedals ok. However for some reason the feet on the side of case are on what would be considered the lid in such a scenario so serve no purpose what so ever. Not sure if I got a one off mistake or there all like that. It's not a problem with weight of pedals and you can always stick some rubber pads on if it is. Looses a star for that but overall it's good value and easier and quicker than a pedal board.
Verified purchase: Yes | Condition: New
In terms of quality, it's fine, it's well built and sturdy enough to protect whatever goes inside. The added sheet of foam is an absolute bonus and one that the bigger companies who charge up to 5 times more should really think about including! What took me about 15 minutes to understand is why the feet have been attached to the side that has the handle and latches on? That's the bit you remove and is usually the 'Lid' so the side that has no latches and no handle stays on stage as a 'Board' to use the pedals inside. So going by this logic, if I put it down, what's inside is upside down and that's not happening. So I'll have to fit some more feet on the other side at some point but that's not a big thing and not difficult to do. The single strip of Velcro has been sewn in which is very thoughtful but you guys used the wrong side and attached the hook tape when it should really be carpet tape and hook tape on the pedals. Again it's no big deal because I bought this for a BOSS GT100 Multi FX and unless I put a sheet of MDF or PLY in there it sits too low to use, so that strip of velcro will hold that 'Base' in nicely for me. All in all, I'm very pleased with it for £23 and it beats keeping what is a very big Multi FX unit kicking around in its original box and I'm not phased by the few small mods this product needs to fit my needs. If you're thinking of buying this as a Fit-and-forget product you might be a little surprised but for the price of it, a few bits from a hardware shop and 20 minutes work is hardly a reason to say no and then go and pay 5 times this much for something that isn't strictly 5 times better!Read full review
Verified purchase: Yes | Condition: New
