Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Parking Sensors
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Parking Sensors
Great product, easy to fit with the hole cutter included. Simple wiring job with the buzzer and control module hidden away at the side of the boot. Buzzer can be heard from driving position no problem. Getting the bumper off and back on again is the most difficult part, but different for every car. Very happy.
Verified purchase: Yes | Condition: New
These sensors come colour matched and so look great on the car. Simple to fit from instructions provided. The hardest part was tracking down the correct wires from the wiring loom in the boot of the car. Once a decision was made on where best to place the actual sensors I used decorators tape to mark out the holes and then drilled the holes using the hole cutter provided. Press the sensors through the holes. I used a quick wpray of wd40 to help them to seat flush. Thread all the wires through to the boot area where the black control box is to be situated. You need to keep track of which is which to make the connections. Connect to the reversing light wire. Test the system by engaging reverse and then place a hand in front of the sensors one by one . All OK ?. Job done. About 2 hours max to fit .Read full review
Verified purchase: Yes | Condition: New
This set or reversing sensors / alarm was easy to fit and connect to my old van. The alarm is very loud so a small piece of masking tape over the item made it perfect. Would definitely recommend the set.
Verified purchase: Yes | Condition: New
I installed these sensors on my daughters Mazda 2 and they work well. The colour, city grey, was a very close match to her car. Fitting the sensors is straight forward once you have taken time to align all four. Running the wires was tricky and we needed to remove the rear light unit to gain access to power. As the speaker is very loud, it does not need running to the front of the car. We were able to house all parts next to the spare wheel. The wires were at least twice the length that was needed, so have plenty of tape at hand to hide the wire behind the trim in the boot. Tony
Verified purchase: Yes | Condition: New
Very inexpensive especially considering the sensors are coloured. Paint finish was very good. All components and connectors seem robust and went together with few problems. Did need to do a little additional filing to get sensors into bumper after using supplied holesaw, but really no complaints for the money. Time will tell how long lasting it will be, but very good so far.
Verified purchase: Yes | Condition: New