I repair a lot of chainsaws. I've tried some of the "low cost" upper end kits with mixed results. The major problem I've seen with the low cost kits is the quality of the piston and ring. You never need to open the ring end gap because it's typically a few thousandths over spec right out of the box. This NWP kit is a little more expensive than the "low cost" option but the quality appears to be much higher. The ring was laser etched with the diameter on the top side and the initial end gap was a couple thousandths tight which allowed me to adjust it to the minimum spec. After a half tank of break in the compression was right on new spec. Time will tell but I expect the durability to be great. I highly recommend this product!
Verified purchase: Yes | Condition: New
This kit had every part that I need to rebuild the top end of a 350 Husqvarna saw, kit work great. Kenny
Verified purchase: Yes | Condition: New
This is the first Meteor kit I've bought to rebuild a saw. I've tried several other aftermarket kits, but none of them compare to the quality of this aftermarket kit.....I was super impressed with it! I would highly recommend this kit if you're wanting something cheaper than OEM but better quality than the other aftermarkets.
Verified purchase: Yes | Condition: New
High quality cylinder & piston, a really good and affordable choice compared to oem kit. Just remember to use oem piston wrist pin circlips, clips that come with the kit are too soft.
Verified purchase: Yes | Condition: New
These guys are honest and guarantee everything. Highly recommended.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Chainsaw Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Chainsaw Parts